LED display maintenance specification steps

LED display belong to high-tech electronic products, the production cost is also very expensive. Due to the LED display will be loose because of pollution, in the process of using, vibration, fever, and environmental factors such as temperature change of fault, thus affect the normal use of the screen, and even cause serious accidents. Display maintenance, therefore, becomes an important content in the work. So powerful giant colour to explain what steps LED display maintenance specification. First, to conduct regular screening for general LED display security are adopt 'month check system', while the large LED display 'week inspection system'. 1, the degree of every month regular technical personnel on-site inspection, check and maintenance on the system. 2, for outdoor display screen, such as wind, rain, thunder, electric injury caused by natural factors, is not in the scope of the warranty. To the owner to the insurance company is cast protect, pay by insurance company. The general faults of 3, during the maintenance service, 8 hours to solve the problem of maintenance, major accident is not more than 24 hours. Maintenance to replace modules such as accessories, not more than 24 hours. After completion of maintenance, ensure that the screen does not appear module level above (by service Such as partial color, module black, a column is not bright, etc. ) Failure, normal play. Of 4, major events, the company technical personnel to guide and ensure the on-site activities smoothly. Second, to display the clean-up for screen protection grade is low, especially the outdoor screen, dust in the air from the vent easily into the equipment, will speed up the fan equipment wear and damage. Dust may also fall on the surface of display internal control device, reduce the thermal conductivity and insulation performance, in wet weather when dust absorbing moisture in the air will lead to short circuit; Long-term can also lead to PCB and electronic components of mildew, the equipment technical performance, fault occurs. Therefore, display the cleanup looks be like simple, but in fact is an important step in the maintenance work. Three, regular display screen fittings of fastening work belongs to high power consumption equipment of LED display screen, when running after a period of time, due to stop and run for many times, including the terminal of the power supply part due to the hot and cold can cause looseness, contact not firm, form virtual connect, serious when fever, even raising beside the plastic components. Signal terminals will be due to the environmental change of temperature cold heat is loose, high lead to poor contact, then result in equipment failure, so must be carried out on the fittings of LED display fastening on a regular basis. In fasteners, during adjustment should be forcibly even properly and ensure solid and effective. Fourth, the LED display to display surface cleaning work regularly cleaning aerial work, should be equipped with professional cleaning team. Cleaning the overhead wire way ( Commonly known as spider-man) Or use hanging bar, allocation of professional cleaning equipment, cleaning personnel according to the different dirt of screen choose different targeted cleaner, to ensure that under the premise of without causing damage to the LED tubes and mask to complete the work of cleaning the screen. Cleaning ready to need to pay attention to two points: first, before cleaning, need to put the power cord. Second, the choice of cleaning fluid, in general, a cleaning liquid electrolyte, high-purity distilled water, anti-static fluid and so on, to choose the good quality, in order to effectively clean the dust on the screen and other stains. Specific cleaning maintenance is divided into three steps: first step: aspiration. First gettering, remove dirt and dust on the surface of the display mask. The second step: wet cleaning. Note cannot put lotion spray directly on the screen, but will a little spray cleaning fluid on a clean cloth, then wipe gently along the same direction. Can also use a vacuum cleaner on the soft brush to scrub, tubes mask will flush clean dirt. Step 3: drying. After using vacuum suction wet wash water mark, to ensure that the display screen mask clean without dust.